scarlson wrote:They look nice.
How are they wired up? Do they all have high/low for tail and brake/turn signals? If you don't mind, where can I find these lights?
They are wired with all three red on each side functioning as tail lights. Additionally the outside light on each side works as the turn signal and the middle two work as the brake lights.
Parts used:
Plastic electrical boxes (Lowes or Home Depot)
Trailor marker lights (Advanced Auto or PepBoys)
Guts from trailor lights (Walmart)
bicycle tube for rubber gasket (Walmart)
Aluminum foil (stole from wifes cabinet)
Wiring harness from old light assembly
Cut the tabs off plastic electrical boxes
Drill holes for mounting screws and line box with aluminum foil
Disable a regular trailer brake/turn/tail light assembly for the guts (sorry only have picture of the guts but this was just a cheap $6 light from Walmart)
Mount guts in plastic electrical box
Disassemble trailer marker lights
Carefully cut the cone shaped light holder off the back of the plastic chrome piece and then make the hole as big as you can to allow as much light as possible through to the lens
Cut rubber gaskets for both exterior/interior mounting surfaces
I just used the clear lights as they came from the store along with a plastic electrical box for backup lights.
Wire it up to the orginal wiring harness and mount on car (sorry I guess I didn't take pictures of this part).
