Rear disc removal

txSteve · Post by **txSteve** » Tue Nov 29, 2011 9:51 pm

I am replacing discs all around. The front discs pulled off no problem. However, the rear ones will not pull off; either of them. Am I missing some step to get those off?

htchevyii · Post by **htchevyii** » Tue Nov 29, 2011 10:43 pm

They should come right off, same as the front. are they rusted to the axles?

txSteve · Post by **txSteve** » Tue Nov 29, 2011 11:07 pm

Note sure. How would I tell?

redek · Post by **redek** » Tue Nov 29, 2011 11:58 pm

When I replaced my front disks, I had to beat them with a dead blow hammer to remove them. I used some anti-seize between the mating surfaced so they wouldn't rust together in the future.

124JOE · Post by **124JOE** » Wed Nov 30, 2011 12:39 am

i used a BIG F HAMMER and hit between the studs to break it free then pull.

txSteve · Post by **txSteve** » Wed Nov 30, 2011 12:51 am

A little PB and few swings from my little sledge and it came off. this seems to be a recurring troubleshooting step

Kent124 · Post by **Kent124** » Wed Nov 30, 2011 8:59 am

Rubber mallet did mine.

Rear disc removal

Rear disc removal

Re: Rear disc removal

Re: Rear disc removal

Re: Rear disc removal

Re: Rear disc removal

Re: Rear disc removal

Re: Rear disc removal