Blinker kit from mark

[Tobi]

Post up some pics topless

Not sure if I want to see that

[fiat218]

Lol sick sick, on topless

[fiat218]

Don't JACK UP that light install

It been jacked up for a week, installed the starter

[fiat218]

Yea I want to see what you did topless lol
Show a photo

[toplessexpat]

First car on the left on this thread chaps...

http://www.fiatspider.com/f08/viewtopic ... 16&t=22839

... let me know if you want me to actually master the art of posting pictures

A

[toplessexpat]

Ok - I took a stab at uploading a better pic....

[toplessexpat]

Post up some pics topless

Not sure if I want to see that

Didn't we have a whole thread around those kinds of photos some time ago that got shut down (eventually!)... and reasonably so!

[fiat218]

Post up some pics topless

Not sure if I want to see that

Didn't we have a whole thread around those kinds of photos some time ago that got shut down (eventually!)... and reasonably so!

Lol. Yup

[toplessexpat]

Here are the ones I used.

https://www.chevsofthe40s.com/detail/15 ... _Turn.html

[fiat218]

What the catch on putting the nut on theses blinkers
Driver-side blinker in the hole,
Standing in front of the car I got the right nut on, not a problem,
LEFT side? Grrrrrrr took the grill out just to try get the nut started, finally 20 min later I get it It started, Anyways how in the Sam dicken do you tighten it up,? Don't tell me with a wrench lol I know that much
Ok tell me

[toplessexpat]

Your left nut is giving you trouble?

Universal joint on a socket ?

[fiat218]

Haha yes left, I tried that there no room, but I will try harder
Thanks, I even used a 1/4 socket set, smaller


I will be in touch ,bye bye

[davery]

Here are the ones I used.

https://www.chevsofthe40s.com/detail/15 ... _Turn.html

I have looked at these for a couple of months now. Is there anything special you need to do, or is plug and play?

[fiat218]

For me it was plug in and play, the only problem I had was that the auto store by my house carried the 4mm bullets male ends, and it was to small for the female end on the light harness so I check a few place,same result, I just cut the male end off the harness and use that for the end on the car,then just did connection on the one I cut, works for me
, it would have been better to have the right size male bullet, but what could I do,

[toplessexpat]

Here are the ones I used.

https://www.chevsofthe40s.com/detail/15 ... _Turn.html

I have looked at these for a couple of months now. Is there anything special you need to do, or is plug and play?

If you mean the LED ones? You need to change your flasher relay to one that isn't looking for the load of the incandescent bulb, hook up the right wires for the turn signals and park lights to the corresponding ones on the vehicle, and off you go.

A