Shift Foam/Rubber Thingy

unplugged · Post by **unplugged** » Sat Jan 29, 2011 3:00 pm

The installation of the rubber/foam piece that surrounds the stick shift.

Is it installed as Pic #1 or Pic#2

Pic#1

Pic#2

Thanks

manoa matt · Post by **manoa matt** » Sat Jan 29, 2011 6:18 pm

Picture #1 is correct. If installed as in picture #2 you would never be able to screw down that secondary stamped sheet metal plate.

Just make sure when you do install the metal plate you get a good seal around the perimeter or you may get some fumes in the cabin.

unplugged · Post by **unplugged** » Sun Jan 30, 2011 11:29 am

thanks

coopertl · Post by **coopertl** » Mon Jan 31, 2011 4:40 am

Please excuse the tag on. . .i recently replaced this boot and when i removed the old torn one, the top of the transmission had oil pooled around the base of the shift level. Not much, maybe 15-20cc. Any idea of the source/cause? Thanks, terry

Shift Foam/Rubber Thingy

Shift Foam/Rubber Thingy

Re: Shift Foam/Rubber Thingy

Re: Shift Foam/Rubber Thingy

Re: Shift Foam/Rubber Thingy